I can see part of the "Sellout" button at the bottom of my screen, but only about half of it. Why only allow it to move side to side? So far not only can I not see the entire button, also I can't seem to use it. left click just makes it disappear and right click does nothing, unless that's happening off screen somewhere I can't see it.
I sort of see whats going on now I think, it has a different part to it at the top of the screen. Great Idea but sort of cumbersome at the start. Anyway to adjust the transparency and fix the sellout button?
There should already be an update that fixes the filters and armory checks.
You can only see part of the button because your resolution is set so low and I haven't yet fully fixed the scaling problem that this introduces, and the patch has really killed my time for little fixes like this.
It's only allowed to move side-to-side because the little system I built is still a work-in-progress, and it was better than making you type code into the console to re-open it after closing.
And yes, I realize the "opening as collapsed" is not ideal, will be fixed next go-round.
yes convert is working through amoury again thx ace
Thanks for the reply and your hard work. Nice to know you're actually up on these issues. So in short, it works and just give it time to work out all the little bugs.
I attempted to fix the resolution issue on the button bar yesterday, tested at several different resolutions and seemed normal all in all, let me know if it still appears incorrect at some resolution that I haven't yet tried.
(03-02-2016, 02:38 PM)Ace Wrote: [ -> ]I attempted to fix the resolution issue on the button bar yesterday, tested at several different resolutions and seemed normal all in all, let me know if it still appears incorrect at some resolution that I haven't yet tried.
I'm using 1920x1051 windowed and still having the issue.
Hey Ace I went back a couple of pages like 5 or so and i havent seen anyone else post this. Is there any chance you can add a reduce now button? Also when my inventory fills up it reduces 2-3 items and stops even though I have a full inventory of reducible items. Any chance you can look into this? Thanks
Hey ace have you got around to checking aetherial reduction? it's not working I even went as far as a fresh install
Nvm not fixed ace still having problems