06-29-2016, 10:43 PM
Elizasleyn, how you use this for A8S. I have so much difficult setup for add and balls that i gave up and just do it manually.
Can you share your adaptation?
Can you share your adaptation?
06-29-2016, 10:43 PM
06-30-2016, 02:49 PM
Added a quelling toggle for manual control.
07-01-2016, 01:08 AM
Is this change had been pushed out yet Ace? I don't see the toggle.
07-01-2016, 11:59 AM
It stopped using cross class skills after update. only using it up when Destroy is enabled
07-01-2016, 09:48 PM
There weren't any changes other than adding the Quelling toggle, so you have a setup issue.
If Destroy makes them fire then either they shouldn't fire because the mob is too weak, or you have a misconfigured Advanced tab.
If Destroy makes them fire then either they shouldn't fire because the mob is too weak, or you have a misconfigured Advanced tab.
07-02-2016, 10:43 AM
@Crayfish the opener and up until ball phase is sort of manually done as it's impossible to kill the orb for me if it does the entire opener.
Also wanted to note that it sometimes re-applies straight shot when there's 8-12 seconds remaining on the buff itself. It usually happens when Destroy/CDS/Buffs are all turned off. Not sure if it helps but i dont think it's intended. Haven't found out the true cause to it i'll keep looking and see if i can reproduce the situation.
@Edit, Yes i made sure to check the setting of when straight shot should be re-applied. It's the default which is <- 2.5s.
Also wanted to note that it sometimes re-applies straight shot when there's 8-12 seconds remaining on the buff itself. It usually happens when Destroy/CDS/Buffs are all turned off. Not sure if it helps but i dont think it's intended. Haven't found out the true cause to it i'll keep looking and see if i can reproduce the situation.
@Edit, Yes i made sure to check the setting of when straight shot should be re-applied. It's the default which is <- 2.5s.
07-03-2016, 05:28 AM
The cause is that it re-aligns the timer if other buffs will fall off depending on your debuff timers as well.
I've never seen +10 seconds happen unless the timers were completely off base.
The 2.5s is really a baseline for you to adjust as needed, most people can get away with practically 0, there's a reason it's an option.
I've never seen +10 seconds happen unless the timers were completely off base.
The 2.5s is really a baseline for you to adjust as needed, most people can get away with practically 0, there's a reason it's an option.
07-04-2016, 09:58 AM
I notice Flaming Arrow (ground AoE) is applied even if I toggle AOE off using the Quick Toggle.
I would suggest it either needs its own dedicated toggle or should obey the AoE toggle.
Reason for this being there are times it is inappropriately applied, such as in a raid (e.g. A1 Faust) when there are adds present but you don't want to target them - but the bot logic places Flaming Circle anyway.
I would suggest it either needs its own dedicated toggle or should obey the AoE toggle.
Reason for this being there are times it is inappropriately applied, such as in a raid (e.g. A1 Faust) when there are adds present but you don't want to target them - but the bot logic places Flaming Circle anyway.
07-11-2016, 02:04 AM
Really amazing, thank you.
07-13-2016, 11:43 AM
(07-04-2016, 09:58 AM)vlahn Wrote: [ -> ]I notice Flaming Arrow (ground AoE) is applied even if I toggle AOE off using the Quick Toggle.
I would suggest it either needs its own dedicated toggle or should obey the AoE toggle.
Reason for this being there are times it is inappropriately applied, such as in a raid (e.g. A1 Faust) when there are adds present but you don't want to target them - but the bot logic places Flaming Circle anyway.
I'm very sure it's because you have destroy/cds/buffs on as it won't fire off flaming arrow when they're turned off together with aoe. However, A1 faust i don't see why you would'nt want to put flaming arrow down as it's free dps done upon faust, it's not like you're gonna get aggro off the adds anyway.