[UnisonRaid]

Using the 50-60 pack as an AST. It seems to never actually use any offensive spells, only heals my companion. It will, every time without fail, just heal and the companion does not do enough damage on it's own. Is there a setting I am missing or a way to adjust it? Would make it go so much faster. Other than that it seems to work great.

[Latty79]

If you are using the ACR profile for AST, the heal ally toggle covers chocobo I think. If you are using a regular skill profile, try using a different one on the forums.   This has nothing to do with the quest profile.

[UnisonRaid]

If you are using the ACR profile for AST, the heal ally toggle covers chocobo I think. If you are using a regular skill profile, try using a different one on the forums.   This has nothing to do with the quest profile.

I managed to get it to work - thanks for your help! I just adjusted it myself a little and enabled party combat. 

I will note that it seems to get stuck on certain quests where a quest giver has multiple quest and or quests that require you to go to a specific location to 'investigate'. It kinda gets stuck in a loop and tries to talk to the quest giver. I also ran into an issue with Quest ID 1770. For some reason it just ends up sitting in a specific spot and looping through commands. It looks like the interact but there is nothing nearby to interact with and I am not sure which quest it's on. 

Thought i'd let you know, otherwise it's been good so far!

[killerjim]

1-70 all DRK lv 63 keeps going to Fabrellet but that npc does not offer a quest. So it just opens the dialog over and over. Any ideas why?

Quest ID 1973
Obj Index 1
Step Index 4

[raif]

Can't seem to get the bot to attack, it will run me right up to the mob and target and that is it. runs everywhere for all the quests though. Using 1-50

[Latty79]

I'm guessing your skill profile is set to None? Need to select a proper one in the dropdown list.

[drissma]

Lately, the profile has been randomly turning "skip cutscenes" and "skip dialogue" on and off for me, which results in my character standing in front of a quest NPC with a speech bubble open for hours, as the profile seems to always turn off "skip dialogue" right before it talks to a NPC. At first I thought it was just a toggle problem (i.e. the profile would turn it on if it was turned off right before talking to a NPC), but no matter if it's turned on or off, it just gets completely stuck at every single Stormblood NPC it talks to because it always gets turned off.

What am I missing here?

[Latty79]

Lately, the profile has been randomly turning "skip cutscenes" and "skip dialogue" on and off for me, which results in my character standing in front of a quest NPC with a speech bubble open for hours, as the profile seems to always turn off "skip dialogue" right before it talks to a NPC. At first I thought it was just a toggle problem (i.e. the profile would turn it on if it was turned off right before talking to a NPC), but no matter if it's turned on or off, it just gets completely stuck at every single Stormblood NPC it talks to because it always gets turned off.

What am I missing here?

Might have those enabled.   The profile doesn't control cutscene / dialog toggles btw, the questing module does.

[drissma]

Oh! That could actually be. I'll check it once I'm back home.

Thanks for the heads-up!

[yukyukboy]

On the level 66 MSQ named "Naadam", during the single trial the bot simply stays at the first part of the trial and continually kills NPC's that will keep respawning. I waited for about 15 minutes (30 minute long trial) before deciding to finish the duty myself. Ideally, the bot is supposed to go down towards the "ovoo" and interact with it, but it did not seem to do so.