[etb]

Hello, here is the mesh i use intented to farm fates on South Shroud / Quarrymill





How to use ?

-Check Do Fates
-Check Fates only

+Rep if you like.

[dv73]

Working pretty good. Thanks!

[kinosix]

i made one yesterday gona try urs though let u know how it works out

[OogieBoogie]

Just started running this. So far so good. Only thing that will make this better is when mounts get implemented :) which I hope is soon.

[Icaros]

Works well.

It does get caught on the entrance to the Scirocco FATE though.
Is there a way to delete from a mesh without scrapping the whole thing?

I set my EvacPoint to Buscarron's Druther's until about 24, since the 21-15 fates are on that side of the map.

[dv73]

^^^

I'm getting stuck as well. 18x y22.

Can't figure out how to trim the mesh.

[lilj0nyeah]

Crashed soon after starting this mesh. Prob not a mesh problem though =/...Don't know what happened b/c I was afk

[lilj0nyeah]

Running a lot smoother now, and I haven't changed anything on my end. I did notice to make sure you have Do fates check-marked otherwise you will run into some fates where he just targets the mob and doesn't attack them.

[Cardsmall]

Yeah I'm getting stuck on that same entrance point. How do you edit a mesh?

[gawc]

Yeah I'm getting stuck on that same entrance point. How do you edit a mesh?

A nice mesh indeed, there are some missing, and stuck a few places, I like to know how to edit one too...figured if you use current mesh, write a new name, and save it on that name, you have current mesh on new name and you can add to it...
But I would really like a delete function too...