[koikoikoi]

the pine log/resin flight profile doesn't work correctly, it just stops on 1 position and stays there. If there are nodes near the position it gathers them but then it just goes back to the same point and just waits there. If i try and start it near a different node, it attempts to gather the node, then teleports to house of the fierce, then to namai, and finally it flies to the same spot and just waits there.

Opening the console shows this after it stops:

D = "[MoveToNode]: Final position x = 708.58312988281,y = 127.36710357666,z =-351.24740600586"