06-17-2014, 07:43 PM
what jackie said, just use the bot to make the mesh it takes 2 seconds. I only used meshlab to fix up some problem areas which is RARELY needed
Thread Rating:
|
Editing meshes
|
|
|
| Messages In This Thread |
|
Editing meshes - by oreidenewyork - 04-29-2014, 05:26 PM
RE: Editing meshes - by HansW - 04-29-2014, 07:33 PM
RE: Editing meshes - by oreidenewyork - 04-29-2014, 09:52 PM
RE: Editing meshes - by oreidenewyork - 05-04-2014, 03:12 AM
RE: Editing meshes - by TauTau - 05-05-2014, 12:32 PM
RE: Editing meshes - by Muffins - 06-16-2014, 05:35 AM
RE: Editing meshes - by Cichard - 06-16-2014, 01:49 PM
RE: Editing meshes - by oreidenewyork - 06-17-2014, 07:43 PM
|
Users browsing this thread: 2 Guest(s)