So, I have been doing this, on beta though (not sure if that's the problem) by turning the mesh manager to "none" and un-checking activated. It still loads meshes. I wish i could load a gif so ya'll could see. When I teleport to a new zone it changes from Activated un-checked and NavMesh "none" to Activated checked and Navmesh to the zone I just teleported into. It doesn't stay un-checked and none.
EDIT: If I do none and CHECK activated it works for about 3-4 zones then goes back to switching to whatever zone I am in and begins loading meshes again. Very strange that it works for a short time then stops.
EDIT: If I do none and CHECK activated it works for about 3-4 zones then goes back to switching to whatever zone I am in and begins loading meshes again. Very strange that it works for a short time then stops.