[Charles082986]

I followed the tutorial at http://www.mmominion.com/Thread-Tutorial...iled-Nodes, but the bot doesn't teleport out of Limsa.

The console error I get is:

D = "SetNavPath - Invalid node IDs"
D = "fromID: 129"
D = "toID: 402"
failed with [string "H:\MINIONAPP\Bots\FFXIVMinion\LuaMods\/ffxivminion/ffxiv_common_cne.lua"]: 1000: Destination position invalid.

The zone I'm trying to teleport to is Azys Lla, so I'm assuming the problem is the bot doesn't know how to teleport to AL yet, and that ID is invalid.

If this is the root cause, is there a workaround available?

[Latty79]

https://www.dropbox.com/s/6j09gffotdxinv...a.lua?dl=0 stick that in your luamods\ffxivminion folder

[Charles082986]

That worked! Though it revealed another issue, which is that instead of flying directly to the destination, it runs along the ground until it reaches the closest point to the destination on the contiguous surface on which I start, then runs right off the edge and flies in a straight line into the zone wall forever. The only console message I get that reveals anything is amiss is:

D = WARNING: ml_mesh_mgr.SwitchNavmesh: No Data-file exist: H:\\MINIONAPP\\Bots\FFXIVMinion\\Navigation\\Azys Lla.data".

I grabbed your mesh files from http://www.mmominion.com/Thread-Latty-s-...ard-meshes, which as of about 45 minutes ago was apparently updated. I'll grab the file pack there and see if that fixes this issue.

I just pulled down the mesh file a few hours ago, so I don't know what (if anything) would have been updated between now and then.

[Latty79]

Flying isn't in yet. You can add portal omc's to make it fly from one spot to another though.