[Latty79]

Please report stucks. Don't know if these locations are the best, but it's what I used to level mining. I didn't add paths to the towns, but they aren't far from them. These aren't used for the mining quests, but I might make meshes for them at some point.

1-5: Central Thanalan - Four Sisters
6-10: Western Thanalan - East Hammer
11-15: Western Thanalan - Copperbell Mines
16-20: Eastern Thanalan - Royal Allagan Sunway
21-25: South Shroud - Upper Paths
26-30: East Shroud - Nine Ivies
31-35: Eastern La Noscea - NW of Costa Del Sol
36-40: South Shroud - South of Goblins' Meet
41-45: Upper La Noscea - South of Camp Bronze Lake
46-50: North Thanalan - SE of Ceruleum Processing Plant

Note: I'm keeping the .obj files as is so you can modify them in case I missed a few mining nodes.

Just noticed Gabi did a similar mesh for the level 25 nodes and woohoo88 did the same for the level 40. I should pay more attention before I post stuff :) Feel free to use theirs as i'm sure they did I better job than I did.

Here are the links to their meshes.

Gabi - http://mmominion.com/Thread-South-Shroud...s-Druthers
woohoo88 - http://mmominion.com/Thread-Quarrymill-35-40-Mining

[KaWeNGoD]

Thanks for your work Latty79

[Syther]

You Sir, earned my respect! Thank you very much for this !!

[psychospectrum]

Tried these out a bit last night, the 36-40 and 41-45 ones work great, thanks!

[twister]

Thx works great

[ffffffff]

46-50 does not work properly in my environment
Does not recognize sometimes the point in the upper right

[inokichi]

Yeah it dont work properly for me too

[Latty79]

I left the .obj so you can fix them yourselves. It's not hard.

[Notahacker]

46-50 does not work properly in my environment
Does not recognize sometimes the point in the upper right

same issue here it just stops i tried to edit it but no luck the mesh just wont record close enought

Edit: Went to the point and recorded the mesh using the ctrl key and now its all fine

[Latty79]

Download 46-50fix on the first post and let me know if it fixed it. I ran it for an hour without any problems.