10-30-2013, 02:11 AM
(10-30-2013, 02:04 AM)dannuic Wrote: 1: I'm not sure I understand this. You seem to be confusing Touch and Synthesis (you have the touch costs listed, but are talking about a synthesis problem). But if I understand correctly, I have currently hardcoded in 100% efficiency (since most people use Basic, Careful, or Careful 2) while I figure out the best way to use variable efficiency, so that is known and I am working on it now.
ahh my bad...
I meant the progress Synthesis
Basic Synthesis (no cost)
Standard Synthesis (15 cp)
the cost is irrelevant in this .. issue...
if I check both on, it uses the Standard at first, and I tried it on Mahogany Lumber, wich it completes with 1 Standard, and 2 Basic.
No biggie, just wanted to let you know... I turn Standard off, it is usually right. :)
A little notice here before I head for bed.
the line 565 error, it occur every time I run out of cp and have more then 10 durability left, if I run out of cp and have only 10 left, there is no error.
Haven't tried on one I can reach 100% quality on.